|
Finally end the hassle of crawling underneath your car to uncap your cutout. Eliminate the
dirty job of changing your borla plates. Now you can flip a switch and go from stealthy quiet
to racecar loud in seconds, without leaving your drivers seat with the McCord Power Plate!
Keith,
You'll never believe what happened when I put your plate on.
IT GOT QUIET. God, I love that car.
Even more now that the versatility is back. Just got in from
an hour and half test drive after I got it done. I like the
cutout but after awhile the drone can get annoying too. That's
what makes your plate so great. Open or closed. The best of
both worlds. Even when it's open it's not obnoxious. Just
mellow and deep. I think the butterfly must break up the sound
waves somewhat. Everything was perfect including the cable
length. Good job and thanx for saving my butt.
Robert
NEW!!!
Check out Ed Bon's Custom installation of dual MPP2s and FLP cutouts on his 2002 Corvette!
More
proof we listen to our customer's suggestions! To respond
to the high vibration turbo market, we purchased a new Miller
TIG welder and are now welding the butterfly directly to the
shaft. This makes the connection bulletproof. No more worrying
about screws backing out or breaking like our competition.
Never listen to the plate rattle on the shaft again!
Every MPP is built to rigid specification including:
- 1/2" thick 6061 aircraft aluminum body
CNC cut for an accurate fit
- Precision ground, 1/4", 304 stainless steel
shaft (good to 1600*F)
- Composite INA Frelon lined bearings
- 304 stainless steel butterfly (good to
1600*F)
- Machined stops at open and closed positions
- Stainless steel butterfly welded to shaft
(no screws)
- Aluminum motor mount to isolate heat from
motor
- 4rpm, gear reduced, high torque, DC motor
- 3 way rocker, toggle to open or close,
let off to stop part way
- Omron high quality, waterproof position
indicator switch
- LED indicator mounted near switch indicates
plate's position
- 500mA maximum current draw. Only draws
power when moving or LED is illuminated
- Wired with weathertite connectors
- All joints soldered and shrink wrapped
- Fused for safety with a 1A quick blow automotive
fuse
- High quality Beldon 22 gauge jacketed cable
- Optionally clearanced for short bolts,
no customization required on cutouts
- Fits a wide range of cutouts/downpipes
available on the market today
- No assembly required, ready to install
- Only wiring required is to connect it to
power and ground
- Unit tested to 1200*F (typical exhausts
are 600*F at the cutout)
- Full One year warranty
|
