Ed Bon's Custom MPP2 and FLP Cutout Installation on a 2002 Corvette The ashtray on the left and my custom switchbox I built on the right The FLP cutouts with McCord electrics and the switchbox. I was hoping these was going to just fit in place of the existing FLP cats. They were too wide to fit . Time for 'Plan B'. A closeup of the switchbox Clearance for the switch cut out of the IP trim panel Switchbox and switch installed IP trim panel completed Clearance cut for the switch in the bracket as well Ready for wiring Took the opportunity to add the last bit of insulation I had left out during the sound/heat insulation mod Wire loom added to protect the wiring Laid the cabling out in preparation for the pull up the torque tube tunnel Attached the cable to fish tape with duct tape and pulled it through to the cabin It emerged out of the shifter access hole intact Clearance-notched the shifter isolator for the wiring Re-assembled the console Ready for the actual cutout install at Grand Mufflers in Marietta, Georgia Underside view - ready for the install You can see the electrical plugs I installed tied up with red tie-wraps waiting for the cutouts. Shane at Grand Mufflers did a great install. He used internal welds and positioned the cutouts expertly. He rotated the gearmotors out of harms way and mounted them there. A worm's eye-view. The turndowns are flush with the tank shields and actually have more clearance than the FLP clamps. They are pointed backward and down at about 30 degrees. They work well and sound beautiful.   Click To See A Short (2MB) Movie w/Sound